Help with DIG Command

[samsam]

This from the Basic Stamp Editor Help Say this About DIG Command

DIG Returns Specified Digit of Number
The Digit operator (DIG) returns the specified decimal digit of a 16-bit positive value. Digits are numbered from 0 (the right-most digit) to 4 (the left-most digit of a 16-bit number; 0 to 65535).


value   VAR     Word
idx     VAR     Nib

Main:
  value = 9742
  DEBUG ? value DIG 2                           ' Show digit 2 (7)

  FOR idx = 0 TO 4
    DEBUG ? value DIG idx                       ' Show digits 0 - 4 of 9742
  NEXT
  END
''   File....... SW21-EX28-ADC0831-Simple-Vref.BS2'   Purpose.... Servo control and positioning with a potentiometer'   Author..... (C) 2000 - 2005, Parallax, Inc.'   E-mail..... support@parallax.com'   Started....'   Updated.... 01 SEP 2005''   {$STAMP BS2}'   {$PBASIC 2.5}
This the part of this code that I have a question about is there a way to change it to this 2 digit 12.00 like this
This code below show with 1 digit it like this 1.200
Main:  DO    GOSUB Read_0831                             ' read the ADC    mVolts = result */ Cnts2Mv                  ' convert to millivolts
    DEBUG HOME,                                 ' report
          CRSRXY, 9, 0, DEC result, CLREOL,
          CRSRXY, 9, 1, DEC mVolts DIG 3,
                        ".", DEC3 mVolts ......>>>>>>>> I try ed to change this line " " to this  1 200 show this way
                                                                    I want to change where the "." point is in the display
                                                                    How do i change it       
     PAUSE 100
LOOP

[JonnyMac]

If you have a word-sized variable and want to display it as x.xx (two digits after the decimal) you can do this with DEBUG

  DEBUG DEC myValue / 100, ".", DEC2 myValue

The DIG operator is not required.