Interference with Servos and WickLed

[Ryanm0085]

i notice that my servos are acting correctly when i run the program until it reaches the point where the WickLed flashes on and off.  I have the servos on channels 0-3 and one wickled on channel 8.  The servos start twitching bad.  Any ideas or suggestions?

[JonnyMac]

What program are you running?

[Ryanm0085]

im using vsa...im using the 8 servo 8 relay...i think i may have figured it out.  i used an external power supply to power the servos.  i only conncted the w on the pin connector, not the ground when i connected them to the sx.   however, i used the same power supply, it has 12v, 5v, and ground, to power the SX.  so im not really sure, but thats what i am thinking

[JonnyMac]

You should use an external power supply for the servos (5v to 6v) and you must connect ground of the external supply to the GND terminal on the Prop-SX.

[livinlowe]

One of the issues I am constantly seeing with servos on this board is they require ALOT more current than one would think.