how do you use Pin6 & 7 as ordinary outputs?

[brittio]

It's been several years since I've worked on props, so I'm a rookie again...  I've been searching the forums, but I've had no luck.  I'm building a blinking light as an "attention getter" and for the life of me I can't remember how to get Pin6 & 7 to work as outputs.  If I put the jumpers in the "up" position they stay on, but in the "off" position or no jumper at all they stay off. 

[brittio]

Nevermind, I figured it out.  I was using "num7 = on" instead of "HIGH num7".  I am good now.

[bsnut]

I'm glad you figured it out. Just remember any pins can be set as an input or even a output.