Servo Power Board

[JonnyMac]

Looking to spice up your prop with lots of servos but are concerned about power requirements?  Put your fears aside, the Servo Power Board will give you project the juice it needs to run all those servos.  And it couldn't be easier to use: plug it into your controller, provide 7 to 12 volts and let the SPB provide up to 3A of regulated power to your servos. 

http://www.efx-tek.com/php/store/index.php?main_page=product_info&cPath=2&products_id=45

[youngti]

I was looking over the instruction and it dosn't say how to connect to the prop controller. In the pictures it looks like the power, ground and signal all go to the board, but i'm not following how to control the servo's from the prop.

[JonnyMac]

The SPB mates to the controller just like a Prop-1 Trainer; the secondary servo header (right edge of SPB) uses the high-current power supply the board.