Connecting servo's to Prop-1

[deadhaunts]

Where do I find information on connecting servos to the Prop-1?  Is there a schematic or wiring diagram somewhere?

Thanks

[JonnyMac]

Pretty much plug-and-play.  A servo has a female, 3-pin connector on it.  The Prop-1 Px pins have male, 3-pin headers associated with them -- just match the colors (white, red, black) with the WRB markings above the headers.  If your servo uses yellow, brown, and black wiring then yellow goes to W, etc.

[deadhaunts]

Got it.  I had it plugged into P1 and I guess the program was looking for P0 and all it did was move a little, then stop.