Adjusting servo position with a pot

[JackMan]

Is there an easy way (or any way) to adjust a servo's position by connecting a pot to the Prop-1? For example, lets say you have the servo programmed for 150 but you need to tweak it without reprogramming the Prop-1.

[JonnyMac]

Sure, why not. What I would tend to do is use the pot to create a scaling factor for the relay position.

[bsnut]

Are you looking to keep the servos position after you manually changed it's position and after you've powered down and powered back up?

[JackMan]

Are you looking to keep the servos position after you manually changed it's position and after you've powered down and powered back up?

Yep, once the servo position is adjusted with the pot, it would need to retain that setting unless the pot is changed.

Update: OK, that was easy, got it working. Thanks Jon!  8)

[bsnut]

Update: OK, that was easy, got it working. Thanks Jon]

Great too hear Jack that you got it working. I love it when someone can push the easy button so quickly. Do you have code to share with us?

[JackMan]

It was pretty much all in the BASIC STAMP EDITOR Help file for the POT command. Didn't think to look there first.  ::)