Buy Now!

Description
Type-A to mini type-B. Cable length is six feet and it is USB 2.0 compatible.

Accessories
• Prop-1 USB Adapter
• Prop Plug
• USB-to-Serial Adapter

Buy Now!

Description
Standard serial cable for Prop-1 programming (with the BS1 Serial Adapter), Prop-2 programming, and Prop-SX programming (with SX-Key or SX-Blitz).

Accessories
• BS1 Serial Adapter
• Serial Inverter

Buy Now!

Description
This 14-inch (35 cm), three-pin (female-female) extension cable is used for connecting the Prop-1, Prop-2, or Prop-SX to other devices (e.g., the AP-8, DC-16, FC-4, RC-4, Prop-Pot) and pin-compatible sensors (e.g., PIR).

Buy Now!

Description
68-inch (5 feet, 8 inches -- 175 cm), three-pin (female-female) extension cable is used for connecting the Prop-1, Prop-2, or Prop-SX to other devices (e.g., the AP-8, DC-16, FC-4, RC-4, Prop-Pot) and pin-compatible sensors (e.g., PIR). Contructed from heavy-guage (#22) wire to ensure good signal strength from end-to-end.

Note: 14" cable pictured -- 65" cable is similarly constructed.

Buy Now!

Description
If you've ever wanted to use a single "wall wart" to run a prop controller and a powered accessory like the FC-4, now you can.

Using the pigtail is as easy as connecting the "+" lead to the V+ terminal of your controller and the "-" lead to the GND terminal of your controller -- then plug the barrel connector into you accessory and you're good to go! Move your accessory's power switch to its "On" position and when the prop controller power switch is moved to P2 the accessory will operate. Yes, it's that easy.